Install Modified Firmware

From hummy.tv Wiki
Revision as of 19:33, 1 November 2011 by Ezra pound (talk | contribs) (HD Fox T2)
Jump to: navigation, search

The procedure for upgrading Humax software, (both original and modified) differs slighty for for the HDR and HD models. Please see the relevant section below.

HDR Fox T2

  • Download the firmware and, if it is a zip file, extract it
  • Rename the resulting file as HDR_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 formatted USB Flash Drive *
  • Put the unit into standby using the remote or big button on the front
  • Make sure that the unit has completely shut down by listening for the hard drive to power down (accompanied by a click)
  • Plug the USB Flash Drive into a USB port
  • Turn on the TV and switch to the Humax input
  • Start up the Humax using the big button on the front
  • The software update should begin automatically and the progress shown on the TV screen
  • The initial download is very quick and then programming takes 2-3 minutes
  • When the update is complete End will appear on the front display and Success Downloading! will appear on the TV
  • Unplug the USB Flash Drive
  • Press the big button on the front again to restart with the new firmware

HD Fox T2

  • Download the firmware and, if it is a zip file, extract it
  • Rename the resulting file as HD_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 formatted USB Flash Drive *
  • Put the unit into standby using the remote, or power button on the front
  • Plug the USB Flash Drive into the USB port
  • Turn on the TV and switch to the Humax input
  • Press and hold down the power button on the front until you see the software update begin, and the progress is shown on the TV screen
  • The initial download is very quick and then programming takes 2-3 minutes
  • When the update is complete End will appear on the front display and Success Downloading! will appear on the TV
  • Unplug the USB Flash Drive
  • Reconnect external hard drive (if used)
  • Press the power button on the front to restart with the new firmware


To Install a Full Web Interface Continue HERE


Note Note: Some USB Flash Drives* are reported not to work, The reason for this is not fully understood, However the following Tips are known to help :-

  • Ensure no other USB devices are connected
  • Do not use a USB extender cable
  • Removing all other files / re-formatting can prevent file fragmentation
  • Try both USB ports (HDR)
  • Last Resort, Try a different USB Flash Drive