Difference between revisions of "Install Full Web Interface"

From hummy.tv Wiki
Jump to: navigation, search
Line 1: Line 1:
Following the successful upgrade of modified software it is possible to access the Humax from a networked
+
Once the custom firmware has been successfully installed, a simple web interface will be available which will allow for installation of the full web interface. This is known as bootstrapping the web interface. Internet access is required as the web interface and its dependant packages are downloaded from the Internet and installed as required.
  
P.C. running Internet Explorer by entering http://10.0.0.4 (NOTE:- the 10.0.0.4 must be replaced with the IP address of your Humax)
+
First, verify that your Humax has Internet access be using the Humax TV Portal to access some content. Then, using a web browser on a device on the same network as the Humax, enter the IP address which has been assigned to the Humax into the address bar.
  
The Following message will now be displayed :-
+
To determine the IP address of your Humax, use the TV On-screen menus to navigate to XXX -> XXX -> XXX...
 +
 
 +
Then enter that IP address directly into the address of your favourite web browser (this process has been reported to work with Firefox, Internet Explorer, Safari and Mobile Safari).
 +
 
 +
The Following message should be displayed in your web browser, confirming successful installation of the custom firmware:
  
 
[[File:Installation_Interface.png|500px|border]]
 
[[File:Installation_Interface.png|500px|border]]
  
Clicking the download button should display :-
+
To bootstrap the web interface, click on the yellow button. It may take up to a minute for anything to appear in the browser depending on the speed of your Internet connection and the browser used. Once output starts, you should see a list of packages being downloaded and installed:
 
 
{{Note|Depenging on the speed of your Internet connection, it may take up to 30 seconds for anything to appear after clicking the button.}}
 
  
 
[[File:Downloading_Web_Interface.png|500px|border]]
 
[[File:Downloading_Web_Interface.png|500px|border]]
 
A list of packages being downloaded are then displayed
 

Revision as of 14:15, 16 August 2011

Once the custom firmware has been successfully installed, a simple web interface will be available which will allow for installation of the full web interface. This is known as bootstrapping the web interface. Internet access is required as the web interface and its dependant packages are downloaded from the Internet and installed as required.

First, verify that your Humax has Internet access be using the Humax TV Portal to access some content. Then, using a web browser on a device on the same network as the Humax, enter the IP address which has been assigned to the Humax into the address bar.

To determine the IP address of your Humax, use the TV On-screen menus to navigate to XXX -> XXX -> XXX...

Then enter that IP address directly into the address of your favourite web browser (this process has been reported to work with Firefox, Internet Explorer, Safari and Mobile Safari).

The Following message should be displayed in your web browser, confirming successful installation of the custom firmware:

Installation Interface.png

To bootstrap the web interface, click on the yellow button. It may take up to a minute for anything to appear in the browser depending on the speed of your Internet connection and the browser used. Once output starts, you should see a list of packages being downloaded and installed:

Downloading Web Interface.png