WebIf Remote Controller
The IR package adds a fully functioning Remote Controller to the Web-Interface, It can be installed from the Web-If >> Package Management page and once installed a ‘Remote’ icon will be added to the Web-If Main screen
CHANNEL SHORTCUTS
Change
- allow quick selection of a new TV/Radio station from a list
Customise
- Add/Remove Favourite quick select channel Icons
- Block remote control mode change icons on TV
- Swap INFO and LIST commands
- Disable Volume Control
- Use Custom Map File
The custom map file must be named /mod/boot/ir3.map and be of the form <original keycode>:<replacement keycode>:<comment>. Here are some examples including a macro on the Subtitle button
0e:43:MENU -> INFO 1f::VOL+ disabled 40::VOL- disabled 4d:43:LIST becomes INFO 43:4d:INFO becomes LIST 46:40,40,40,f2,c,3,a:Subtitle button = VOL-, VOL-, VOL-, WAIT 2 seconds, 0, 1, 8
Notes
- Use ir -l to show code mappings.
- Delays can be added to macros by using fX where X is the number of seconds to wait as a hex digit, so f1 for a second, f9 for 9 seconds, fb for 11 seconds up to fe for 14 seconds
- Web-If >> Diagnostic >> File Editor >> /mod/boot/ir3.map shows the default code mapping
- Select an alternative Remote Control Mode (1-6)
Also available in Web-If >> Settings >> Remote Control Settings
If you have forgotten which mode your original Remote Control is in, holding 0 + OK for 5 Seconds will reveal it on your TV screen
MACROS
- record a sequence of key strokes, to be replayed with a single 'click'
- A Macro named root will automatically be run when the Humax is taken out of standby
Selecting Record a New Macro will display a Name Box and some delay keys to create a pause in the sequence
HISTORY
Displays a clearable list of commands sent
MOBILE VERSION
There is a mobile version of the Web-If Remote Controller that is more suited to the ‘small screen’. If the IP address of your humax is 10.0.0.200 then the mobile version’s address would be :- http://10.0.0.200/plugin/ir/m/
There are three selectable screens that display Remote - Favs - Macros
COMMAND LINE OPTIONS
The IR package is also controllable as a command line via Telnet, here are some examples :-
humax# status
Watching 7: BBC THREE - This Is BBC Three (05:30 - 18:58) [48%]
ir SEVEN DELAY1 TWO OK
SEVEN (0x9)
DELAY1 [delay between 1-99 Seconds]
TWO (0x4)
OK (0x13)
humax# status Watching 72: CITV - Horrid Henry (12:00 - 12:15) [13%]
REMOTE CONTROL MODE SETTING
From the command line it is possible to enable the TV screen Mode Display / Set function :-
ir CURMODE MODE
To set the Humax to Remote Control Mode 1 from the command line :-
ir CURMODE MODE DELAY2 MODE1
NOTE
The Web-If Remote Controller can only control your Humax, the 'TV' 'DVD' and 'AUDIO' mode buttons will not control other equipment
