Install Modified Firmware

The procedure for upgrading Humax software, (both original and modified) differs slighty for for the HDR and HD models. Please see the relevant section below.

Note: Some USB flash drives are reported not to work. If you have problems, ensure that you do not have a USB extension cable connected and try a different flash drive. On the HDR, priorities for scanning the USB ports vary depending on other connected devices so try both USB ports

HDR Fox T2

• Download the firmware and, if it is a zip file, extract it;
• Rename the resulting file as HDR_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 formatted USB Disk (flash or externally powered);
• Put the unit into standby using the remote or big button on the front;
• Make sure that the unit has completely shut down by listening for the hard drive to power down (accompanied by a click);
• Plug the USB disk into the front or rear USB port;
• Turn on the TV and switch to the Humax input;
• Start up the Humax using the big button on the front;
• The software update should begin automatically and the progress shown on the TV screen. The initial download is very quick and then programming takes 2-3 minutes;
• When the update is complete End will appear on the front display and Download Successful will appear on the TV;
• Press the big button on the front again to restart with the new firmware.

HD Fox T2

• Download the firmware and, if it is a zip file, extract it;
• Rename the resulting file as HD_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 formatted USB Disk (flash or externally powered);
• Put the unit into standby using the remote and then physically unplug the device from the mains;
• Plug the USB disk into the rear USB port, first unplugging any connected hard drive;
• Turn on the TV and switch to the Humax input;
• Holding down the power button, connect the Humax to the mains;
• The software update should begin automatically and the progress shown on the TV screen. The initial download is very quick and then programming takes 2-3 minutes;
• When the update is complete End will appear on the front display and Download Successful will appear on the TV.