Install Modified Firmware

The procedure for upgrading Humax software, both original and customised (Modified) is detailed below.

HDR Fox T2

• Download the firmware and, if it is a zip file, extract it
• Rename the resulting file as HDR_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 formatted USB Flash / disk Drive *
• Put the unit into standby using the remote or big button on the front
• Make sure that the unit has completely shut down by listening for the hard drive to power down (accompanied by a click)
• Remove all USB devices
• Plug the USB Flash Device containing the HDF file into a USB port
• Turn on the TV and switch to the Humax input
• Start up the Humax using the big button on the front
• The software update should begin automatically and the progress shown on the TV screen
• The initial download is very quick and then programming takes 2-3 minutes
• A list of possible Error codes that may be displayed are detailed HERE
• When the update is complete End will appear on the front display and Success Downloading! will appear on the TV
• Unplug the USB Flash Device containing the HDR_FOX_T2_Upgrade.hdf file
• re-connect any other USB devices e.g. Wi-Fi adadper, Hard disk Drives etc. (ensure that the HDF file is not present)
• Press the big button on the front again to restart with the new firmware

HD Fox T2

Note: The HD Fox T2 requires a USB Flash / Disk Drive with a minimum of 2GB to be connected when operating with Custom Firmware otherwise it will not be possible to install additional software packages.

• Download the firmware and, if it is a zip file, extract it
• Rename the resulting file as HD_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 USB Flash / Disk drive *
• Put the unit into standby using the remote, or power button on the front
• Plug the USB Flash device into the USB port
• Turn on the TV and switch to the Humax input
• Press and hold down the power button on the front until you see the software update begin, and the progress is shown on the TV screen
• The initial download is very quick and then programming takes 2-3 minutes
• A list of possible Error codes that may be displayed are detailed HERE
• When the update is complete End will appear on the front display and Success Downloading! will appear on the TV
• Unplug the USB Flash Device and delete the HD_FOX_T2_Upgrade.hdf file
• Reconnect the USB device
• Press the power button on the front to restart with the new firmware

To Install a Full Web Interface Continue HERE

Note: Some USB Flash / Disk Drives* are reported not to work, The reason for this is not fully understood, However the following Tips are known to help :-

• Ensure no other USB devices are connected
• Do not use a USB extender cable
• Removing all other files / re-formatting can prevent file fragmentation
• Try both USB ports (HDR)
• Last Resort, Try a different USB Flash Drive