Difference between revisions of "Install Modified Firmware"
Ezra pound (talk | contribs) |
Ezra pound (talk | contribs) (→HDR Fox T2) |
||
| Line 3: | Line 3: | ||
==HDR Fox T2== | ==HDR Fox T2== | ||
| − | * Download the firmware and, if it is a zip file, extract it | + | * [[Firmware_Downloads | '''Download the firmware''']] and, if it is a zip file, extract it |
* Rename the resulting file as ''HDR_FOX_T2_Upgrade.hdf'' and place it in the root of a FAT32 formatted USB Flash Drive * | * Rename the resulting file as ''HDR_FOX_T2_Upgrade.hdf'' and place it in the root of a FAT32 formatted USB Flash Drive * | ||
* Put the unit into standby using the remote or big button on the front | * Put the unit into standby using the remote or big button on the front | ||
Revision as of 19:32, 1 November 2011
The procedure for upgrading Humax software, (both original and modified) differs slighty for for the HDR and HD models. Please see the relevant section below.
HDR Fox T2
- Download the firmware and, if it is a zip file, extract it
- Rename the resulting file as HDR_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 formatted USB Flash Drive *
- Put the unit into standby using the remote or big button on the front
- Make sure that the unit has completely shut down by listening for the hard drive to power down (accompanied by a click)
- Plug the USB Flash Drive into a USB port
- Turn on the TV and switch to the Humax input
- Start up the Humax using the big button on the front
- The software update should begin automatically and the progress shown on the TV screen
- The initial download is very quick and then programming takes 2-3 minutes
- When the update is complete End will appear on the front display and Success Downloading! will appear on the TV
- Unplug the USB Flash Drive
- Press the big button on the front again to restart with the new firmware
HD Fox T2
- Download the firmware and, if it is a zip file, extract it
- Rename the resulting file as HD_FOX_T2_Upgrade.hdf and place it in the root of a FAT32 formatted USB Flash Drive *
- Put the unit into standby using the remote, or power button on the front
- Plug the USB Flash Drive into the USB port
- Turn on the TV and switch to the Humax input
- Press and hold down the power button on the front until you see the software update begin, and the progress is shown on the TV screen
- The initial download is very quick and then programming takes 2-3 minutes
- When the update is complete End will appear on the front display and Success Downloading! will appear on the TV
- Unplug the USB Flash Drive
- Reconnect external hard drive (if used)
- Press the power button on the front to restart with the new firmware
To Install a Full Web Interface Continue HERE
Note:
Some USB Flash Drives* are reported not to work, The reason for this is not fully understood, However the following Tips are known to help :-
- Ensure no other USB devices are connected
- Do not use a USB extender cable
- Removing all other files / re-formatting can prevent file fragmentation
- Try both USB ports (HDR)
- Last Resort, Try a different USB Flash Drive
